All Magnate bandsaw blades are welded and fabricated in the USA. The coils/material of the bandsaw bladesare USA brands. The picturedepicts a generalbandsawblade and thus may lookdifferent fromeach particular item.Note: theimage shows only one single blade. For packaging purposes, this blade is folded into a coiled position which is similar to a spring and may pop open when uncoiled. Wear leather gloves and eye/body protection while using extreme care when uncoiling the blade. Failure to exercise the proper care could result in serious bodily injury. See your bandsaw owner's manual for further safety instructions. Please refer to your owner's/operation manual tomake sure the blade's length, width andthickness can fit your bandsaw machine. Use with a wood cutting band saw, ( DO NOT use a metal-cutting bandsaw ). This gullet edge, tungsten carbide particle grit bandsaw blade is ideal for cutting applications involving materials with a cross section greater than 1/4 (6.4mm). It cuts abrasive and hardened materials such as wire reinforced rubber, steel belted radial tires, ceramics, fiberglass, composites, hardened steel, cast iron (grey with voids), graphite, and case hardened materials. The following bandsaw models use 120 inch ( 10 ft., 10' ) bandsaw blades. Grizzley G0659 9"x 14" Vertical (Metalcutting); Dake 14-10; Dake SXC; General International 90-840 M1; JET VSF-14-1, VSF-14-3