Welbilt Bread Machine Heavy Duty Pan Seal and 50 similar items

This new "Pan Seal Kit for the mini-loaf pan" Includes: Heavy Duty Seal, Stainless Steel Flat Washer, Stainless Steel Snap Ring, Stainless Steel E-clip. will fit the model listed below: Welbilt Automatic Dough Bread Maker Machine Model Number: ABM1L2P THANK YOU! Bread Machine Parts Finder ***Important message about replacing the seal in the pan: The old red seal issued with the pan was manufactured with an outer diameter of 19mm. The 19mm outer diameter seal was cut down to 17mm by the manufacturer of the pan to make it fit into the 17mm diameter hole of the pan. This action reduced the outer layer (mil) of the seal leaving it vulnerable to failure by weakening the seal's ability to maintain a sealed environment for the bearing assembly. Some of the seals will not stay in the pan's recessed hole. The seal will make it's way out during the mixing or kneading phase. Even after firmly pressing the seal back into place it will still eventually work its way back out again. The second problem with the cut down seal is that it may be cut crooked when reducing the diameter. This will result in failure to maintain a sealed environment as well as becoming stuck within the pan's recessed hole. This creates a third problem. When a seal is stuck within the pan's recessed hole it makes it very difficult to remove. At least 50% of seals cut crooked that are stuck in the pan's recessed hole will not come out without damaging the pan's recessed hole. If the hole is damaged while removing the seal from the pan it cannot be repaired. The pan will never seal again. ***If the seal is making its way out on its own during the mixing or kneading phase, then you will be able to easily install a new seal. ***If you have to remove the old seal by tapping the drive shaft through to push it out and the seal easily pushes through with minimal force applied, then you will be able to easily install a new seal.***If the seal is very difficult to remove or will not budge unless excessive force is applied, then you will most likely damage the pan's recessed hole making the non-repairable. *** I strongly recommend removing the old seal before purchasing a new seal so that you can determine if the pan is in fact repairable.***My new seals are manufactured with an outer diameter of 17mm. Never cut down or reduced to fit! This solves the problem with the old red seal!